McIntosh MX121 with Original Mic, Stand, and Remote

Description: McIntosh MX121 with Original Mic, Stand, and Remote McIntosh MX121 with Original Mic, Stand, and Remote General: No more fiddling with individual bands, settings, etc., to get the best sound possible in your home theater. Some of the HDMI features and standards may be older, but best results are usually achieved from running your sources directly to your display anyway. Most importantly McIntosh put a lot of effort into the analog section making this one of the more musical processors on the market - perfect for two channel as well as theater use. This McIntosh MX121 comes with its original box, mic, mic tripod, and remote. SkyFi Cosmetic Notes: A light scratch is present on the left side panel. SkyFi Technical Notes: This unit was fully tested for audio use. No HDMI testing was performed. Please note that this processor may not be fully compatible with some current HDMI protocols and UHD (4K) resolutions. Brand Background: McIntosh Laboratory is an American manufacturer of handcrafted high-end audio equipment based in Binghamton, New York. The company was founded in 1949 by Frank McIntosh. The company designs and produces audio amplifiers, stereo tuners and other consumer electronics products. Ownership: Single Owner Connections: 6 HDMI inputs 2 Outputs, RCA inputs, XLR Balanced Inputs and Outputs, Coax and Optical video inputs, Component video Inputs and Outputs, Ipod/usb, Network. General Sound: Neutral sound with little to no coloration Cosmetic Condition: 8/10 = Very Good. Excellent front faceplate, one minor flaw on chassis side or top. Working Condition: Working perfectly and tested in our lab and listening room. Included: Exactly as pictured and described above. Packing: Original Manufacturers Packing Specs: Frequency Response ±0.5dB from 20Hz-20,000Hz Total Harmonic Distortion 0.005% maximum from 20Hz to 20,000Hz at rated output Signal To Noise Ratio Phono: 86dB below 10mV input (A Weighted) High Level: 96dB below rated output (A Weighted) Rated Output Voltage 2.5V Unbalanced Outputs (Main Zone) 5.0V Balanced Outputs (Main Zone) Maximum Voltage Output 6V Unbalanced 12V Balanced Output Impedance 220 ohms Input Impedance Phono: 47k Ohms, 65pf High Level: 20k Ohms Unbalanced and Balanced Sensitivity for Rated Output Phono: 4.5mV High Level: 450mV Unbalanced, 900mV Balanced Maximum Input Signal Phono: 50mV High Level: 4.5V Unbalanced and Balanced Tone Controls Bass Control: ±6dB at 30Hz Treble Control: ±6dB at 10,000Hz Dimensions: Width is 17-1/2 inches (44.45cm) Height is 7-5/8 inches (19.37cm) including feet Depth is 19-1/2 inches (49.53cm) including the Front Panel, Knobs, Rear Panel Connections and USB Drive Weight: 30 lbs. Approximate Age: 2012 Testing Process: We start with a visual inspection of all internal components to make sure that there are no signs of heat stress or damage. Capacitors are checked for telltale signs of predictive failure including bulging, shrunken wrappers, or physical leakage. We also inspect the PCBs for discoloration from resistors or transistors that may have been running hot. On vintage units we often spot check select capacitors for value and ESR. When we first power on a preamplifier we connect its RCA output to a Sencore PA81 Power Analyzer which simulates real world loading conditions and gives us an oscilloscope interface. The first order of business is checking that the volume control works smoothly throughout its entire range with acceptable channel balance. This is accomplished by feeding a 1 KHz sine wave into one of the preamp’s line level inputs while monitoring the preamp’s output on an oscilloscope. We then switch to a 1 KHz square wave to test the tone controls, loudness function, and filters where applicable. During this step we are watching for equal alteration of the test signal by both channels. This also helps us identify dirty controls that will need treatment. Once the basic line stage functions are verified, we test each input individually. This is especially important for devices that use relays to select their sources. If the preamp is equipped with a phono stage we test that as well. We use an inverse RIAA filter which allows us to feed a reference test signal into the phono input with the proper RIAA equalization and level. A square wave or sine sweep is uséd to verify that the device’s phono stage is faithfully reproducing the RIAA curve. If the preamp under test has balanced inputs and/or outputs these are tested as well. We finish up our bench testing with a listening test with our bench amplifier and reference speakers. During this test we check for hum or hiss that may not have shown up in earlier testing. We also check that all of the tone controls and filters perform as expected. If the preamplifier has remote control functions these are also tested. Preamps with tube circuits or complicated power supply topologies are connected at our long term test rig for extended stress testing under real world conditions. ---------- SkyFi Audio - Curators of Vintage Audio Gear SkyFi Audio is a small startup business specializing in the purchase, reconditioning, and reselling of high end audio equipment. We only buy equipment that we admire and are passionate about. No mid-fi, no gimmicks, no junk. Each piece of equipment is cosmetically restored and fully tested in our well-equipped lab by an engineer with 30+ years of experience in the HiFi world. If it does not meet or exceed the original manufactures specifications, it will not be sold. We are very selective about the equipment we purchase, focusing on mostly analog, high-build quality, American, and European built units. Please note we are not a repair shop and only restore what we own. ---------- PURCHASING GUIDELINES: 1) This item will be professionally packaged and insured for safe transit to your home unless you opt for local pickup from our shop. All local pickup items are only wrapped in industrial strength clear stretch wrap if the original manufacturer packaging is unavailable. Local pickup is available in Glen Rock, NJ, 07452, just a half hour drive from Midtown Manhattan, with convenient parking near our building. If we don’t have the original packaging, we use heavy-duty double-ply corrugated boxes with custom made to your item SealedAir Instapak expanding foam custom inserts. In many cases this has proven to be better than the original packaging! We also use high quality fiber reinforced tape to seal our packages. Lightweight items will be bubble wrapped and shipped in a high-quality box. 2) We will not review or accept any offers that do not go through the official eBay system. We have too many items for sale and it’s nearly impossible to keep track of offers outside of the official system. Please do not message, email, or text any offers. 3) All listings are eligible for the eBay Global Shipping Program unless the item exceeds the maximum weight/price requirements to your country. If this is the case simply message us via eBay. We only accept bank wire transfers for international payments and frequently ship worldwide via UPS. 4) Please ensure your shipping address is correct within eBay as we will ONLY ship to the eBay/PayPal Confirmed Shipping Address. No exceptions. 5) eBay may charge and collect sales tax to your state/jurisdiction which we have no control over. eBay v1.8 × Buy now and save! Tell a friend Visit store Watch now Postage info UPS Ground - $0.00 Local Pickup - $0.00 Click the Postage tab above the listing description for more info Additional delivery notes PICK UP OPTION Our items are available for pick-up. Pick up procedure is as follows: Purchase the item through eBay Email us to coordinate pickup PAYING VIA PAYPAL We accept PayPal on our all our items so you can shop with confidence. Simple choose the PayPal option when proceeding through the checkout. Additional Information No additional information at this time Ask seller a question You might also like Dynavector 10x3 High-Output MC Phono Cartridge Music Reference RM-5 MK II Tube Preamplifier with Phono WyWires Silver Series Phono Interconnects - 5 Pin DIN w/ XLR Connectors - 4ft Music Reference RM-9 Tube Amplifier With EL34's Contact To contact our Customer Service Team, simply click the button here and our Customer Service team will be happy to assist. Ask seller a question © SkyFi Audio Postage Click the Postage tab above the listing description for more info Payment Accepted Payment Methods PayPal Returns Returns are not accepted Seller will pay for return shipping. eBay integration by

Price: 3200 USD

Location: Glen Rock, New Jersey

End Time: 2024-11-13T08:51:24.000Z

Shipping Cost: 0 USD