Description: 3d printed GI Joe Classified Unpainted Cobra Vest sized for larger figures Will not fit all 1:12 figures. Original Vest by figuregear.com Disclaimers and instructions: This is an unpainted 3d printed vest. It is very susceptible to UV light until it is coated with either a clear coat or paint. Please remember to protect it from sunlight until finished. Use hot water or a hair dryer (not my preferred) to warm the vest so you can shape it on the figure you want. Please handle with care. To shape the vest for the desired figure. Gently warm the vest in water (boil water and remove it from heat. Let cool a little) or with a hair dryer. CAREFULLY as to not damage the item or paint. Shape vest to figure and cool in ice water or glue the vest tabs to hold it in place. NO FIGURES ARE INCLUDED. ONLY THE VEST. All items are made and painted by hand. There will be differences and imperfections in each piece. I strive to make quality items. Please understand that these are more fragile than a manufactured item. Please handle them with care. Weapons, heads, shields, and jet packs are made with resin that is slightly flexible. Most items have been coated with a primer that seals the item and may be minimally painted. The intention for my products is for the customizer to utilize and for the items to be further painted and detailed. However, for those of you that don’t paint, I try to have items with some detail painted. This is very time consuming, so these may be rare instances. Wearable items are made with Siraya Tenascious 70/30 mix to provide strength and flexibility. If you purchased pre-painted items, the paint may cause the item to be more rigid. You may need to heat items and shape them to your liking (Hot water may be the safest method). Most vests will need this to fit properly and fasten onto a figure. Once in place, I recommend gluing the connectors. All heads will need to be fit to your chosen body. Dremeling, putty, etc will be needed to ensure a proper fit. I use a method that utilizes hot glue. Use petroleum jelly on the neck peg. Fill the head hole with enough glue to push the peg into the head and some of the glue to squeeze around the neck ball. As it dries, continue to move the neck peg so it will not bind in the hole. Thank you so much for considering a purchase!
Price: 16.99 USD
Location: Roseville, California
End Time: 2024-11-28T08:39:28.000Z
Shipping Cost: N/A USD
Product Images
Item Specifics
All returns accepted: ReturnsNotAccepted
Type: Does Not Apply