Crossover PCB for the Pit Vipers DIY speaker design

Description: Custom printed circuit board designed to work with the crossover of the Pit Vipers DIY speaker design by Paul Carmody. Take the guesswork out of crossover assembly, these boards make the process quick and straightforward. The crossover board measure 6.5" x 5.4" and feature large solder pads and copper traces for great electrical connectivity. Includes: 1x Crossover PCB for the Pit Vipers DIY speaker design. 4x Terminal blocks which accept up to 12 gauge wire. 4x Snap in PCB standoffs. 4x Mounting screws (screw finish may vary). Requires: Crossover components for the Pit Vipers speaker design. Compatible components this PCB is designed to fit: C1 - 6.8uF - Dayton Audio DMPC-6.8 C2 - 50uF - Parts Express 50uF Non Polarized Electrolytic C3 - 12uF - Parts Express 12uF Non Polarized Electrolytic C4 - 2.2uF - Dayton Audio DMPC-2.2 C5 - 150uF - Parts Express 150uF Non Polarized Electrolytic L1 - 0.25mH - Dayton Audio 0.25mH 20 AWG Air Core -or- Jantzen 0.25mH 20 AWG Air Core L2 - 1.2mH - Dayton Audio 1.2mH 18 AWG Air Core -or- Jantzen Audio 1.2mH 18 AWG Air Core L3 - 1.0mH - Dayton Audio 1.0mH 18 AWG Air Core -or- Jantzen Audio 1.0mH 18 AWG Air Core L3 - 5.0mH - Dayton Audio 5.0mH 18 AWG I-Core -or- US Coils 5.0mH 18 AWG I-Core R1 - 4.7 Ohm - Dayton Audio DNR-4.7 -or- 4.7 Ohm 10w wirewound sandcast/ceramic resistor R2 - 1 Ohm - Dayton Audio DNR-1 -or- 1 Ohm 10w wirewound sandcast/ceramic resistor R2 - 10 Ohm - Dayton Audio DNR-10 -or- 10 Ohm 10w wirewound sandcast/ceramic resistor Assembly: Glue components to the correct positions on the board (hot melt glue works great). Secure inductors with non metallic cable ties. Solder components leads to the pads on the bottom of the board. Attach wires from input and drivers and mount crossover board.

Price: 13.89 USD

Location: Millbrook, Illinois

End Time: 2023-12-03T04:40:32.000Z

Shipping Cost: N/A USD